Skip to content

Proxy Usage Alerts for Pay-Per-GB Traffic: What to Set Up

Know what you will and will not be told before the traffic runs out, and set a threshold of your own.

Which notices exist and which do not

Auto-renew is optional and set per IP. When it is on, the renewal runs from the wallet balance in the last 24 hours of the lease. If the balance is too low, an email goes out, and there is a last reminder under 4 hours before the end.

For per-GB traffic the situation is different: the GB you bought stay until you use them, and this page does not state any threshold email. That is not a defect in your account, it only means you should read the number yourself.

What runs out, and what to watch

What runs out, and what to watch
ItemPrepaid GBPay as you go from the walletPer-IP lease (auto-renew is optional)
What runs outGB you boughtPTC wallet balanceDays of the lease
Does it expireNo, marked No expiryThe balance stays until usedYes, on the end date
Where to lookGB left in My assetsWallet balance, and the minimum shown before generatingEnd date and wallet balance
Notice documented hereNone, check yourselfNone, check yourselfEmail when the balance is too low to renew

Source: Proxy302 product facts and the pay-per-GB guide, read on 17 November 2026.

Set a threshold in runs, not in gigabytes

A number such as "alert me at 5 GB" says little, because one job may use 0.3 GB and another 8 GB. Measure one real run, then keep a reserve of a few full runs of your largest job.

How many GB a job needs is covered in the sizing guide. The reserve itself is your own rule of thumb, not a Proxy302 setting.

Set up your own alert in five steps

  1. Step 1

    Run one real job and note the GB used. Before and after, read the remaining GB in My assets; the difference is the cost of one run.

  2. Step 2

    Decide the reserve, for example 3 full runs of your biggest job. Write both numbers where your team sees them.

  3. Step 3

    Before every big job, read the GB left and run the helper below. If it prints ALERT, top up first.

  4. Step 4

    If you work with an AI assistant, proxy302-mcp has a tool for account usage and wallet balance, so you can ask for the numbers instead of opening the console. It cannot buy anything.

  5. Step 5

    Auto-renew is optional. For leased IPs, keep it on only for IPs you want to keep, and keep the wallet above the renewal price. Turn it off per IP in My assets, Details.

A ten-line alert helper

# Usage-alert helper: you type the numbers, it tells you when to top up.
# Usage: python alert.py GB_LEFT GB_PER_RUN RESERVE_RUNS
import sys

gb_left, gb_per_run, reserve_runs = (float(x) for x in sys.argv[1:4])
runs_left = gb_left / gb_per_run
print(f"{gb_left:g} GB left = about {runs_left:.1f} runs of {gb_per_run:g} GB")
if runs_left < reserve_runs:
    print(f"ALERT: fewer than {reserve_runs:g} runs left, top up before the next job")
else:
    print("OK")

Example: python alert.py 12 4 3 prints 12 GB left = about 3.0 runs of 4 GB, then OK; python alert.py 7 4 3 prints about 1.8 runs and ALERT. It does no network calls.

The proxy stopped and nothing was changed

Requests that worked yesterday now fail, with the same host, port and password.

Check Open My assets: GB left for traffic, or the end date for a lease. For pay as you go, check the wallet balance against the minimum shown on the product page.

Fix Buy more GB or top up the wallet, or renew the lease, then run one small request again.

Stop when If GB, balance and end date are all fine and it still fails, stop retrying and open a ticket with the order number.

Usage alerts FAQ

Are there proxy services with automatic usage alerts?

Some do; it depends on the provider and is written in its own help pages. For Proxy302 this page documents the low-balance email for auto-renewing leases, not a usage-threshold email for per-GB traffic.

Does purchased traffic expire?

No. Prepaid GB are marked No expiry and stay until used.

Where do I see how much traffic is left?

In My assets in the console. proxy302-mcp can also read account usage and wallet balance for you.

Can auto-renew charge me without warning?

Only for IPs where you left it on, and only from the wallet during the last 24 hours of the lease. You can switch it off per IP in My assets, Details.

Reference links

4
  1. Proxy302 product facts and price list

    Product observation · Confirmed on:

    Product facts file of the site (values checked against the console, the backend and the price table in October and November 2026): products, prices in US$ (1 PTC = US$1), lease terms, protocols and ports, renewal rules, no free trial.

  2. Proxy302 guide: pay per GB proxies

    Product observation · Confirmed on:

    Read on 17 November 2026: prepaid GB are marked No expiry in the console; pay-as-you-go shows the rate and the minimum wallet balance before a proxy is generated.

  3. Proxy302 guide: proxy MCP server

    Product observation · Confirmed on:

    Read on 17 November 2026: the proxy302-mcp tools include account usage and wallet balance; the server cannot buy anything.

  4. Example script on this page

    Local example · Confirmed on:

    Run on 17 November 2026 with Python 3 and the sample numbers shown in the code caption; it does no network calls.

Ready to try it?

Create an account, top up once, then pick rotating residential, static ISP or datacenter IPs and have one running in your browser within minutes.